Use an aerosol lubricant to lubricate all the door rollers.
Troubleshooting sticking sliding closet doors.
Sliding glass door repair will get the job done.
If it s a matter of friction on the strike plate try.
See if the screws holding the guides down need tightening to be more secure.
Check out the following sliding closet door symptoms and then follow a fix that best fits the problems you have.
You can order rollers and other door parts for repairing sliding doors through lumberyards and home centers or online.
The first thing to check is what type of rail system your sliding closet door uses in order for it to slide.
Start with a good cleaning.
If the rollers are damaged install replacement rollers available at home centers.
If the door still doesn t slide smoothly the rollers under the door either need adjusting or are shot.
If grime remains try wiping it up with a mild cleaner and a cloth.
Tighten screws gradually and watch the trim to make sure you don t.
Drill through the jamb countersink the screwhead with a countersink bit.
Your door is old and worn out.
Determine where the sticking is happening.
First vacuum loose debris so you can see what you re working with.
To replace the door follow the steps in photo 2 in reverse order.
A dirty obstructed or damaged track can make a sliding closet door jump off its track.
Sliding closet doors are loose and swing in and out.
If your sliding door is sticking or dragging along the tracks making a grinding noise the springs in the rollers could have become loose causing it to sag.
Sliding door tracks are magnets for dirt dust pet hair bugs grass food crumbs you name it.
If the sticking area is along the door frame where the hinges are located.
Next take a dry stiff scrub brush and work through corner to corner.
Drive a screw near the middle of the area where the door is rubbing.
To fix this issue first try vacuuming up debris and grime from the track with a crevice attachment.
Scrub caked dirt and grime out of the track with a stiff brush and soapy water.
Here s how to repair your sliding door and make it run like new.
On the top middle or bottom.
As a last resort loosen the top pivot bracket setscrew and slide the top away from the door frame.
You may need to add a second screw.
The tracks are notoriously difficult to clean so you ll have to pull out all the stops.
To fix this you can adjust the height of the rollers by the screws on the rollers.
You may need to add a second screw.
Or gently lift the door off the lower bracket with a flat pry bar.
If your doors hang from a top rail and do not have a track on the floor then you need to either replace or tighten down the floor guides.
Now precisely where on this part of the door frame does the sticking occur.