In most cases this turns out to be a loose set screw within the door handle or door knob.
Too much play in my door lock.
If it is a threaded shaft you will have to twist the shaft s handle to make it flush with the door.
There are many portable door locks that can be attached to the door to secure it in a few minutes or less.
Locate the two screws that hold the door knob together and tighten them.
A loose door handle usually indicates that there might be something wrong with your door lock.
If the gap along the side of your door is so large that the latch won t catch or barely catches adjusting the strike can reduce the gap to ensure proper operation.
Pull off the knob as you depress the button.
When you use your door a lot you will begin to notice a little bit of play in the door knob.
If exposed screws are being used you will have to find the set screw which is normally found on the inside of the door.
Use a portable door lock.
This problem is easily fixed with a screwdriver.
If the deadlatching function isn t working properly or can be easily defeated by pushing or pulling on the door the first thing to do is to call in a qualified electric hardware installer to examine the door.
Unscrew the strike and slide.
If the stop is keeping the door from closing all the way or if it is too far away so that the door rattles move the stop.
Door lock problems that are a result of debris jamming up the keyway should not be ignored because they can potentially result in more problems like breaking a key in a lock.
Most interior door knobs are relatively inexpensive to replace.
On the latch side a door is cut at a slight bevel to make it easier to close.
First score the paint line where the stop meets the jamb.
Also a broken bolt or latch that causes your door lock to jam might be a symptom of a much larger issue like an attempted home break in.
An improperly functioning latch may be the result of a poorly fitting door.
For serious lock problems it is usually best to call a locksmith or to replace the lock entirely.
Then tap in two putty knives and begin prying.
It doesn t really pay to have interior door knobs or locks professionally repaired unless they are special.
So if you don t have another entry exit point the only way to use a barricade is while you re inside the room.
Using either a screwdriver or allen key loosen the set screw and remove the handle which will uncover the shaft.
Remove the cover plate as well by prying it off with a.
Press the release button on the side of the door knob handle with an awl or narrow screwdriver.